Rick posted on May 07, 2009 22:36
Resurrected from www.disco2.com with some assistance from Google's cache and the Internet Archive. This was convenient for me since I was already under the console installing a D1 shift linkage.
Parts and tools required
- Phillips screwdriver
- Soldering iron
- Crimping tool
- Heat shrink sleeving or insulation tape
- 2.8mm spade connectors
- Light gauge insulated cable to run 2 lengths from the back of the centre console to where you put the switch (binacle or facia panel)
- LR Front Foglight switch, Part # YUG102620
Instructions
- Unclip the gaiter from the Hi/Low stick.
- Unscrew the 2 screws under the gaiter and 2 from within the cubby box.
- Lift the back of the centre console and support.
- Locate a black header block (wires entering from one side only). There will be an orange one next to it.
- Find the 3 Blue/Black wires (they will be at one end) and cut the 3rd one, counting from the edge, about 70mm from the header.
- Solder and insulate the two lengths of wire to the two cut Blue/Black wires.
- Remove blank switch from it's housing and swap the switch front fascia with the fascia of your foglight switch, giving you a proper switch with a blank face.
- Run the two lengths of wire to where you're going to put the switch.
- Remove about 3mm of insulation from the end of the wires and crimp on the male spades.
- Connect wires to terminals 1 & 4 of the switch. The numbers are stamped onto the switch by the terminals.
- Push switch into its housing.
- Now test the system by locking the CDL and switching on the ignition - ETC & ABS lights will stay off after initial diagnostics.
With thanks to Mark Casey